Especificaciones técnicas
Protección y seguridad
| Reverse polarity protection | Yes; against destruction |
|---|---|
| short-circuit proof | Yes |
| Short-circuit protection | Yes; electronic/thermal |
| short-circuit | Yes |
| Isolation tested with | 707 V DC |
| IP degree of protection | IP20 |
| Protection against fouling acc. to EN 60664-3 | Yes; Type 1 protection |
Datos eléctricos
| Type of supply voltage | DC |
|---|---|
| Current consumption, typ. | 40 mA |
| Current consumption, max. | 90 mA |
| Type of input voltage | DC |
| permissible voltage at input, min. | 0V |
| permissible voltage at input, max. | 30 V |
| Type of output voltage | DC |
| Monitoring of the supply voltage (PWR-LED) | Yes; green PWR LED |
Condiciones ambientales
| Installation altitude above sea level, max. | 5 000 m |
|---|---|
| Vibration resistance during operation acc. to IEC 60068 | 10 ... 58 Hz / 0.075 mm, 58 ... 150 Hz / 1 g |
Otras características
| Product type designation | ECC 2x PWM ST |
|---|---|
| FW update possible | Yes |
| based on | 6FE1242-6TM10-0BB1 |
| usable BaseUnits | BU type B0, B1 |
| Number of channels | 2; According to IEC 61851/SAE J1772 |
| I&M data | Yes; I&M0 to I&M3 |
| STEP 7 TIA Portal configurable/integrated from version | see entry ID: 109746275 |
| Mounting type | standard rail |
| Mounting position | Horizontal |
| Rated value (DC) | 24 V |
| permissible range, lower limit (DC) | 19.2 V |
| permissible range, upper limit (DC) | 28.8 V |
| Number of digital inputs | 2; 1 per channel |
| Digital inputs, parameterizable | Yes; 12 V / 24 V |
| Freely usable digital input | No; Readback contact contactor / connector lock |
| for signal "0" | <0.2 V (nom) |
| for signal "1" | >0.6 V (nom) |
| unshielded, max. | 30 m; only when using a PROFIBUS cable |
| Type of digital output | Transistor |
| Number of digital outputs | 2; 1 per channel |
| PWM output | Yes; According to IEC 61851 |
| Number, max. | 2; 1 per channel |
| Cycle duration, parameterizable | No; 1 kHz |
| Connection of a DC motor | Yes; ACT p/n connector locking |
| Number of analog outputs | 2; Control pilot acc. to IEC 61851-1 and/or SAE J1772 |
| Bus communication | Yes |
| Vehicle communication according to IEC 61851 | Yes; MODE 3 |
| Diagnostic alarm | Yes |
| ERROR LED | Yes; red LED |
| Channel status display | Yes; green LED |
| for module diagnostics | Yes; green/red DIAG LED |
| between the channels and backplane bus | Yes |
| Degree of pollution | 2 |
| Electrostatic discharge acc. to IEC 61000-4-2 | 4 kV contact discharge / 8 kV air discharge |
| min. | -30 °C; = Tmin (incl. condensation/frost) |
| max. | 60 °C; = Tmax |
| horizontal installation, min. | -30 °C; = Tmin (incl. condensation/frost) |
| horizontal installation, max. | 60 °C; = Tmax |
| vertical installation, min. | -30 °C; = Tmin |
| vertical installation, max. | 50 °C; = Tmax |
| Storage, min. | -40 °C |
| Storage, max. | 70 °C |
| Transportation, min. | -40 °C |
| Transportation, max. | 70 °C |
| 2-38, max. | horizontal installation |
| Shock resistance acc. to IEC 60068-2-27 | 15 g / 11 ms |
| Resistant to commercially available coolants and | Yes; Incl. diesel and oil droplets in the air |
| 60721-3-3 | Class 3B3 on request |
| to EN 60721-3-3 | 0AA0) |
| conditions acc. to EN 60721, EN 60654-4 and | during operation! |
| Military testing according to MIL-I-46058C, Amendment 7 | Yes; Discoloration of coating possible during service life |
| Qualification and Performance of Electrical Insulating | Yes; Conformal coating, Class A |
| to SIMATIC S7-1500 | Yes |
| Width | 20 mm |
| Height | 73 mm |
| Depth | 58 mm |
| Weight, approx. | 32 g |
| last modified: | 7/17/2025 |